Anonymous
11/9/2025, 8:50:09 AM
No.2848254
[Report]
>>2848255
>>2848262
>>2848279
>>2848319
>>2848326
>>2848366
Wanted to commission a custom-made spear. Any Suggestions?
Obviously idk about the specific measurements for a spear (much less polearms) but what i do know is that for personal use (outside of formations) the total length must be at least close to the height of your doorframe (210cm) but i'm going for the shortest end which is 180cm. The shaft would be 150cm long and the spearhead 30cm, again CMIIW because i'm using the same ratio for straight swords.
The blacksmith recommended me using sleipner steel or D2 for the spearhead, sleipner costs around 191 usd and D2 149 usd, for the shaft he hasn't given me any specifics yet.
For the design, i'm currently going rather simple as starters but suggestions are welcome.
Any advice?
The blacksmith recommended me using sleipner steel or D2 for the spearhead, sleipner costs around 191 usd and D2 149 usd, for the shaft he hasn't given me any specifics yet.
For the design, i'm currently going rather simple as starters but suggestions are welcome.
Any advice?