Search Results
6/24/2025, 3:22:41 PM
>>2926361
I'll put tape over the inlet side to remove any pressure/volume losses. This is gonna be for an extraction system on an old ULS 50 watt laser system (and another one that is either 35 or 45 watts, but not at the same time) The specs on the blower are SUPER close to the requirements for both laser cutters in terms of static pressure, and far exceed them in terms of CFM. Hopefully by using a minimal amount of ductwork and not bothering to use the dust collection bag (this was meant as a dust collector for woodworking) I can get the required static pressure. (I have a meter to measure it just in case)
I'll put tape over the inlet side to remove any pressure/volume losses. This is gonna be for an extraction system on an old ULS 50 watt laser system (and another one that is either 35 or 45 watts, but not at the same time) The specs on the blower are SUPER close to the requirements for both laser cutters in terms of static pressure, and far exceed them in terms of CFM. Hopefully by using a minimal amount of ductwork and not bothering to use the dust collection bag (this was meant as a dust collector for woodworking) I can get the required static pressure. (I have a meter to measure it just in case)
Page 1