Search Results
6/3/2025, 11:48:53 PM
>>2921847
V2+ will be the h-bridge ground connected to ground through a 0.25(?) ohm resistor. Q1c and q2c drive the two h-bridge en pins. The brushed drill trigger (switch & potentiometer) is on the motor side of the h bridge. It's not quite right yet because it should flip on a falling edge preferably with a time delay but I'm optimistic I can fix that.
I don't mean that I can't figure out a flip flop IC or that it isn't the best part for the job. I mean that I have a tendency to hoard so I try to use what I already have.
V2+ will be the h-bridge ground connected to ground through a 0.25(?) ohm resistor. Q1c and q2c drive the two h-bridge en pins. The brushed drill trigger (switch & potentiometer) is on the motor side of the h bridge. It's not quite right yet because it should flip on a falling edge preferably with a time delay but I'm optimistic I can fix that.
I don't mean that I can't figure out a flip flop IC or that it isn't the best part for the job. I mean that I have a tendency to hoard so I try to use what I already have.
Page 1