Search Results
6/16/2025, 7:13:23 AM
>>2924382
i honestly dont think the issue is that canbus lines, the extruder stepper is ON the toolhead board, right next to the motor mount.
circle is where it seems to be grounding, from the mount DIRECTLY onto the driver (blue heatsink is on the other side of the board of the stepper)
you can see the tinfoil grounding pad i attached to the 24v ground line, and you may be able to see the 2 additional grounding wires leading behind the board and onto the other stepper mounting screw to ground it (i can get to this one with just 2 screws undone, as opposed to fully rebuilding the entire clockwork 2) and the cable i jammed into the filament runout sensor hole to brush against the filament and try discharge it, but didn't work.
pardon the mess, ive had the damn thing apart 12 times in the last week, and i've given up on fixing my cable routing
i honestly dont think the issue is that canbus lines, the extruder stepper is ON the toolhead board, right next to the motor mount.
circle is where it seems to be grounding, from the mount DIRECTLY onto the driver (blue heatsink is on the other side of the board of the stepper)
you can see the tinfoil grounding pad i attached to the 24v ground line, and you may be able to see the 2 additional grounding wires leading behind the board and onto the other stepper mounting screw to ground it (i can get to this one with just 2 screws undone, as opposed to fully rebuilding the entire clockwork 2) and the cable i jammed into the filament runout sensor hole to brush against the filament and try discharge it, but didn't work.
pardon the mess, ive had the damn thing apart 12 times in the last week, and i've given up on fixing my cable routing
Page 1