Thread 105874607

I have a Google Pixel 6 with GrapheneOS, and I plan on replacing the battery in it. I am going to perform a backup of the data just in case. I have a 3D printer bed I could use to heat up the screen for removal, along with a hot air rework station. Part of the screen is already separated due to the battery. I have special thin metal tool for prying off the battery, along with a few plastic doritos like the one in this video.
https://www.youtube.com/watch?v=QGGWKij505M

For the 3D printer bed, what should the temperature be? Would it be better if I used the hot air rework station? What temperature should I use for that if so?

What sort of adhesive tape should I get, and would any of you anons recommend using glue instead, and if so, which glue?

>>105874607 (OP)
I also need a little suction cup, since the ones I have in my possession are all $0.10 chinese pieces of shit.

>>105874607 (OP)
You might have more luck asking in >>>/diy/. Good luck.

>>105874628
Thank you, anon. Here's the new thread.
>>>/diy/2930681